I have tried both putting wlan0 into monitor mode manually using: # ifconfig wlan0 downĪnd also using airmon-ng to create a mon0 device: # airmon-ng start wlan0 6 I've made sure the wireless card is on channel 6, the same channel my open network is on. RTL8187 Wireless Adapterīus 001 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub Relevant commands and their outputs are listed below: # lsusbīus 001 Device 009: ID 0bda:8187 Realtek Semiconductor Corp. The USB wireless card I listed (Alfa AWUS036H) is using the rtl8187 driver. I have tested more configurations than I can list, but I'll try to give a good idea of what I've done. The computer I am sniffing from is not connected to any network. The clients that I have set up running pings and http traffic are connected to an open wireless g network. This is the case in kismet, wireshark 1.2.x, 1.4.x, and 1.8.x, and my own packet reader program that uses libpcap. The problem is that while I'm running wlan0 in monitor mode, I only see broadcast packets (I see ARPs, DHCP transactions, beacons, and other random management and data packets that are being broadcast or multicast). Enter grantee code: UQ2, product code: AWUS036H, then clicking "detail" and then "internal photos").
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |